Posts Tagged With: Anacortes

Yet another weekend of upgrades and mods…

SealsStella and I had another great weekend in Anacortes this past Friday thru Sunday.  It’s such an awesome little town!  We had breakfast Saturday at Dad’s Diner on the main drag.  It was excellent!  We also did a bit more exploring around a few more of the docks than just our own. It’s always fun to look at all the other boats.  Many are beautiful, some, not so much.  And a few with so much dirt and grime we’re not even sure there was a real boat beneath! We had one very pleasant surprise when we ran across some harbor seals sunning themselves on the kayak platforms near Q dock.  Two pairs – each with a mother and cub. The pair shown in the picture was definitely keeping their eyes on us.  Another pair on the next slip over tried to slip into the water and come up on the dock with these two, but this mother wouldn’t put up with it.  She started barking like crazy whenever they got close.  She definitely did take up some space, but as you can see, there was plenty to spare. Dad was nearby out in the water, clearly keeping his distance and not wanting to get into any argument with the two ladies!

original galleyBack in our slip, we continued getting Southern Star ready for some travelling by replacing the cabinet door on the front of the galley. The original galley looked like what you see to the right.  On top it has a fiberglass sink with a VERY small drain and a one-burner butane stove.  The space below them is accessible through the door on the front right side. As you can see, the left side is much more difficult to access, with no door – just a couple of small inset shelves.  I totally removed this front panel and repurposed the two small shelves by taking that portion of the front, cutting it down to size and then moving it to the left side of the unit.  Then I finished the front with latching doors attached to roll out wire drawer units (each is about 11″ wide).  I mounted them onto a 1/2 that glued and screwed along the front edge and also about 15″ back.  That raised them just enough to clear the lower lip of the opening. The drawers had an accessory kit that attaches to the front of each for easy mounting of the door directly to the drawer. The alternative was to hinge the doors on the side and then have to pull out the drawer. The Admiral preferred this technique.  WP_20140712_19_55_45_ProWhile the left hand drawer does have some constraints to avoid the plumbing underneath, it gives dramatically better access to the space below the sink.I also replaced the sink with a stainless steel one of (approximately) the same size. I Just cut out the original (using the template supplies with the new one), and dropped the new one in its place. I also replaced the faucet with a much nicer one attached to my water pump and 25 gallon tank under the rear berth.   If you’re curious, the red tape on the left faucet handle “locks” it in the off position. This is for connection to a future hot water supply, but currently is not connected to anything. So if you accidentally open it, water can freely pour out the bottom when you turn on the cold water. Not good. I do need to cap that off!

Then came what I think will be a really big improvement.  I replaced the tank under our Dometic Sealand porta-potty with a tank that had built-in MSD hose fittings. This enabled me to attach it to hoses which lead to deck fittings that enable me to use the WP_20140712_19_56_36_Propump-out facilities at any marina. I no longer have to carry the (very heavy when full) tank to some dump facility to empty it.  That had to be one of the worst tasks on the planet. Doing a pump-out isn’t particularly fun, but it’s a lot better than the alternative!  I plan on moving the air line filter much closer to the back so it is more in the back, though neither hose is in the way.  I’ll also be trying to cover over those hoses so they’re not quite so “in your face” and industrial in appearance. A cover with some carpeting like covers the hull walls might be the ticket there.

The last thing on our plate (for now) is to put a latching cover over the large opening I cut below the galley to make that space accessible to us again, since our galley is essentially fixed in place.  I bought the wood, and I’ll be attaching it to the opening with hinges at the bottom and a latch (identical to the ones on the galley doors) at the top.  That will open up several more cubic feet of storage space that is out of reach to us right now. And in a small boat like this, every cubit foot counts!

Till next time!

 

Categories: Anacortes, Cap Sante Marina, Modifications | Tags: , , , , | Leave a comment

Getting ready for Boating Season 2014

Well, boating season is almost here and we have to get Southern Star ready.  She’s going to have a new home at Cap Sante Marina in Anacortes this year, where the facilities look awesome and the monthly costs are much less than what we were paying in Lake Washington.  The fact that we can drive to Anacortes and be 5 minutes from the San Juan Islands in just an hour and a half is another huge plus – it took over 2 hours to get from our Lake Washington slip all the way out to Puget Sound, and that’s if there wasn’t much of a line at the Hiram Chittenden Locks.  And then there was the several hour motoring through the Sound to get to the San Juans.   So this should save a ton of time and gas!

In terms of getting Southern Star ready, we had her in front of the house all weekend working on her.  So far, we added:

  • A second 12V switch panel to handle power distribution to the new equipment below and for future additions.
  • A dual-voltage refrigerator that auto switches between 110v shore power and 12v battery power.  This should eliminate all trips to get a block of ice!  Now all we’ll need ice for is our evening libations!  I’m still not quite convinced that an ice maker would take up too much space to be worth it!  They only come in 110v form (that I can find) but we’re usually in marinas with shore power.
  • I ran a dedicated power line from the switch panel back to where the TV and video player were mounted.  Up until now, I had a loose cord running from a 12V outlet across the bed and up to the TV.  No more ugly!
  • I rigged a pulley on the center board haul-up line that makes it much easier to raise the board. I’m still waiting for the line splicer devices to finish off the lines in place of the big ugly knots that I have there now.  Should make it much easier for the Admiral to haul it up when we’re getting ready to motor.
  • I installed a spring loaded hatch arm to the bow hatch to make it easier to keep it open for airflow on a hot summer day.  Last year we propped it up with water bottles.  Very attractive!  Now to figure out a fan to help out.
  • The BIG thing was installing the Raymarine Evolution autopilot system.  Still not done, but I’ve mounted the main course computer and the EV-1 sensor unit and ran  the power line.  I still have to mount the control panel and drive motor on the steering pedestal and run all the cables from there back to the computer.  That’s not going to be fun, because it’s almost impossible to get inside the pedestal.  I think that I’m going to have to fish the lines from the cabin below the pedestal, up through the opening in the deck at it’s base.  I have to run three wires through there, one for the drive motor, one for the control panel, and one to connect the GPS to the autopilot. Lots of fun still ahead of me. I did hook all the components up though, and when I turned it on nothing blew up, I let out a big sigh of relief.  And it rated a big cheer when I turned the knob on the control panel and the motor started to turn.  Woohoo!  It works!

Once all this work is done, I’m really looking forward to the summer life of cruising through the islands in our little Home Away From Home!  We want to get her in the water the first weekend in May – that’s the beginning of boating season, and we want to be there for it!

I wanted to give a big shout-out to the guys at West Marine in Bellevue.  Especially Troy the BoatCanDo Guy – he came by for an hour last week and helped me plan out a good bit of this work, letting me bounce ideas off him and providing me with options that I hadn’t thought of.  His advice was invaluable and his fees were very reasonable.  If you’re looking for great advice on making upgrades to your boat – Troy is your man!

Categories: Modifications | Tags: , , , , , , | Leave a comment

Create a free website or blog at WordPress.com.